Config L2Protocol_Tunnel Ports; Show L2Protocol_Tunnel - D-Link DGS-1210/ME Series Reference Manual

Example usage:
To disable the Layer 2 protocol tunneling function:
DGS-1210-28MP/ME:5# disable l2protocol_tunnel
Command: disable l2protocol_tunnel
Success.
DGS-1210-28MP/ME:5#

config l2protocol_tunnel ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the L2PT tunneling on ports 8-12:
DGS-1210-28MP/ME:5# config l2protocol_tunnel ports 8-12 type uni
tunneled_protocol protocol_mac 01-00-0C-CC-CC-CC threshold 100
Command: config l2protocol_tunnel ports 8-12 type uni tunneled_protocol protocol
_mac 01-00-0C-CC-CC-CC threshold 100
Success.
DGS-1210-28MP/ME:5#

show l2protocol_tunnel

Purpose
Syntax
Description
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To configure Layer 2 protocol tunneling on ports.
config l2protocol_tunnel ports [all | <portlist>] type [uni
tunneled_protocol [stp | gvrp | protocol_mac [01-00-0C-CC-CC-
CC | 01-00-0C-CC-CC-CD] | all] | nni | none]
The config l2protocol_tunnel ports command is used to configure
Layer 2 protocol tunneling on ports.
[all | <portlist>] – Specifies a range of ports or all ports to be
configured.
type – Specifies the type of the ports.
uni tunneled_protocol – Specifies tunneled protocols on this UNI
port. If specified all, all tunnel-able Layer 2 protocols will be tunneled
on this port.
stp – Specify to use the STP protocol.
gvrp – Specify to use the GVRP protocol.
protocol_mac - Specify which protocol MAC address to use.
all - Specify to use all the MAC addresses.
nni – Specifies the port is NNI port.
none – Disables tunnel on it. By default, a port is none port.
None.
To show Layer 2 protocol tunneling information.
show l2protocol_tunnel {nni | uni}
The show l2protocol_tunnel command is used to show Layer 2
protocol tunneling information.
341