D-Link DGS-1210/ME Series Reference Manual page 501

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
written to the DSCP field of an incoming packet that meets
the criteria specified in the first part of the command. This
value will over-write the value in the DSCP field of the
packet.
•
rx_rate <value 64-1024000> – Specifies the rate limit to limit
Rx bandwidth for for the profile being configured. This rate is
implemented using the following equation – 1 value =
64kbit/sec. (ex. If the user selects a rx rate limit of 10 then
the ingress rate is 640kbit/sec.) The user many select a
value between 64- 1024000 or no limit. The default setting is
no limit.
deny – Specifies that packets that do not match the access profile
are not permitted to be forwarded by the Switch and will be filtered.
ip – Specifies that the Switch examine the IP fields in each packet to
determine if it will be either forwarded or filtered based on one or
more of the following:
•
source_ip <ipaddr> – Specifies that the access profile
applies only to packets with this source IP address.
•
protocol_id <value 0-255> – Specifies that the Switch
examine the Protocol field in each packet and if this field
contains the value entered here, apply the appropriate rules.
•
destination_ip <ipaddr> – Specifies that the access profile
applies only to packets with this destination IP address.
•
dscp <value 0-63> – Specifies that the access profile
applies only to packets that have this value in their Type-of-
Service (DiffServ code point, DSCP) field in their IP packet
header.
•
icmp – Specifies that the Switch examine the protocol field
in each frame's header and it should match Internet Control
Message Protocol (ICMP).
•
type – Specifies that the Switch examine each frame's ICMP
Type field.
•
code – Specifies that the Switch examine each frame's
ICMP Code field.
•
igmp – Specifies that the Switch examine each frame's
protocol and it should match Internet Group Management
Protocol (IGMP) field.
•
type – Specifies that the Switch examine each frame's IGMP
Type field.
•
tcp - Specifies that the Switch examine each frame's
protocol and it should matchTransport Control Protocol
(TCP) field.
•
src_port <value 0-65535> – Specifies that the access profile
applies only to packets that have this TCP source port in
their TCP header.
•
dst_port <value 0-65535> – Specifies that the access profile
applies only to packets that have this TCP destination port in
their TCP header.
•
flag {+ | –} {urg | ack | psh | rst | syn | fin }} – Specifies the
appropriate flag parameter. All incoming packets have TCP
flag bits associated with them which are parts of a packet
that determine what to do with the packet. The user may
deny packets by denying certain flag bits within the packets.
To specify flag bits that should be "1" type + and the flag bit
name, to specify bits that should be "0" type – and the flag
481