Disable Cpu_Interface_Filtering; Config Flow_Meter Profile_Id - D-Link DGS-1210/ME Series Reference Manual

To enable the CPU filtering on the Switch:
DGS-1210-28MP/ME:5# enable cpu_interface_filtering
Command: enable cpu_interface_filtering
Success.
DGS-1210-28MP/ME:5#

disable cpu_interface_filtering

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the CPU filtering on the Switch:
DGS-1210-28MP/ME:5# disable cpu_interface_filtering
Command: disable cpu_interface_filtering
Success.
DGS-1210-28MP/ME:5#

config flow_meter profile_id

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config flow meter information:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To disable CPU interface filtering on the Switch.
disable cpu_interface_filtering
The disable cpu_interface_filtering command is used to disable
CPU interface filtering on the Switch.
None.
None.
To configure the flow-based metering function on the Switch.
config flow_meter profile_id <value 1-6> access_id <value 1-
250> [delete | rate <value 64-1024000>] burst_size <value 0-
1016> rate_exceed [drop_packet | remark_dscp <value 0-63>]
The config flow_meter profile_id command configures the flow-
based metering function on the Switch.
profile_id <value 1-6> - .Specify the profile id to be configured.
access_id <value 1-250> - Specify the access id to be configured.
rate <value 64-1024000> - Specifies the committed bandwidth in
Kbps for the flow.
burst_size <value 0-1016> - Specifies the burst size
rate_exceed: pecifies the action for packets that exceeds the
committed rate in single rate

drop_packet - Drop the packet immediately.

remark_dscp <value 0-63> - Specify the remark DSCP value.
Only administrator or operate-level users can issue this command.
489