Config Qinq Ports; Config Qinq Inner_Tpid - D-Link DGS-1210/ME Series Reference Manual

Port ID: 2
---------------------------------------------------------
Role:
Miss Drop:
Outer Tpid:
Add Inner Tag:
---------------------------------------------------------
DGS-1210-28MP/ME:5#

config qinq ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure port list 1 to 4 as NNI port, set outer TPID to 0x88a8:
DGS-1210-28MP/ME:5# config qinq ports 1-3 role nni outer_tpid 0x88a8
Command: config qinq ports 1-3 role nni outer_tpid 0x88a8
Success.
DGS-1210-28MP/ME:5#

config qinq inner_tpid

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the inner TPID to 0x88a8:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
UNI
Disabled
0x8100
Disabled
Used to configure Q-in-Q ports.
config qinq ports [<portlist> | all] [role [nni | uni] | outer_tpid
<hex 0x1 - 0xffff> | add_inner_tag <hex 0x1-0xffff> | missdrop
[enable | disable]]
The config qinq ports command is used to configure the port level
setting for the Q-in-Q VLAN function. This setting is not effective
when the Q-in-Q mode is disabled.
<portlist> - A range of ports to configure.
all – Specifies all ports to be configure.
role - Port role in Q-in-Q mode, it can be UNI port or NNI port.
outer_tpid - TPID in the SP-VLAN tag.
add_inner_tag - For inner tag packets.
missdrop - If specified as enabled, the VLAN translation will be
performed on the port. The setting is disabled by default.
Only administrator or operator-level users can issue this command.
Used to configure Q-in-Q inner TPID of the Switch.
config qinq inner_tpid <hex 0x1-0xffff>
The config qinq inner_tpid command is used to configure the inner
TPID for port.
<hex 0x1-0xffff> - Specifies the inner-TPID of a port.
Only administrator or operator-level users can issue this command.
288