Config Erps Raps_Vlan State - D-Link DGS-1210/ME Series Reference Manual

Parameters
Restrictions
Example usage:
To configure the hold off time to be 100 milliseconds, the guard time to be 1000 milliseconds, and the
WTR time to be 10 minutes for R-APS VLAN 4094:
DGS-1210-28MP/ME:5# config erps raps_vlan 4094 holdoff_time 100 guard_time
1000 wtr_time 10
Command: config erps raps_vlan 4094 holdoff_time 100 guard_time 1000 wtr_time
10
Success.
DGS-1210-28MP/ME:5#

config erps raps_vlan state

Purpose
Syntax
Description
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
received R-APS messages will be ignored by this ring node,
except in the case where there is a burst of three R-APS event
messages. This indicates that the sub-ring topology has
changed, meaning that the node needs to flush the FDB that
has been received on the node. In this case, the recovered link
will not go into a blocking state. The Guard Timer should be
greater than the maximum expected forwarding delay for which
one R-APS message circles around the ring.
•
WTR Timer –The WTR Timer is used to prevent the frequent
operation of the protection switch due to an intermittent defect.
This timer is used during the protection switching process
when recovering from a link failure. It is only used by the RPL
owner. When an RPL owner in the protection state receives an
R-APS PDU with an NR flag, it will start the WTR timer. The
RPL owner will block the original unblocked RPL port and start
to send an R-APS PDU with an RB flag after the link recovery
is confirmed within this period of time.
<vlanid 1-4094> - Specify the VLAN ID to be configured.
holdoff_time <integer 0-1000> – Specifies the holdoff time of the R-
APS function. The range is between 0 and 1000, and the default is
0.
guard_time <integer 10-2000> – Specifies the guard time of the R-
APS function. The range is between 10 and 2000 milliseconds, and
the default is 500.
wtr_time <integer 1-12> – Specifies the WTR time of the R-APS
function. The range is between 1 and 12 minutes.
Only Administrator, operator and power user-level users can issue
this command.
Used to configure the state of the specified ring.
config erps raps_vlan <vlanid 1-4094> state [enable | disable]
The config erps raps_vlan state command is used to configure the
ring state of the specified ring's default instance. When both the
global state and the specified ring's default instance ERPS state are
enabled, the specified ring will be activated. STP and LBD should be
disabled on the ring ports before the specified ring's default instance
is activated.
The ring default instance cannot be enabled before the R-APS
VLAN is created and the ring ports, RPL ports and the RPL owner
240