Enable Snmp Traps - D-Link xstack DGS-3620 series Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
74-10 config snmp system_contact
Description
This command is used to enter the name and/or other information to identify an SNMP system
contact person who is responsible for the switch. A maximum of 255 characters can be used.
Format
config snmp system_contact <sw_contact>
Parameters
<sw_contact> - Enter an SNMP system contact person. A maximum of 255 characters is
allowed.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the switch contact to "
DGS-3620-28PC:admin#config snmp system_contact "MIS Department IV"
Command: config snmp system_contact "MIS Department IV"
Success.
DGS-3620-28PC:admin#

74-11 enable snmp traps

Description
This command is used to enable SNMP trap support on the switch.
Format
enable snmp traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable SNMP trap support:
":
M IS D e p ar t m e n t I V
838