Snmp-Server Enable Traps Wireless; Trapflags (Wireless Config Mode) - D-Link DWL-8500AP Command Reference Manual

no ap authentication
The version of this command disables AP authentication. APs are not required to
no
authenticate to the Unified Switch upon discovery.
Format
Mode

snmp-server enable traps wireless

This command globally enables the Unified Switch SNMP traps. The specific wireless trap
groups are configured using the
Default
Format
Mode
no snmp-server enable traps wireless
The version of this command globally disables all Unified Switch SNMP traps
no
Format
Mode

trapflags (Wireless Config Mode)

This command enables Unified Switch SNMP trap groups for wireless system events. If no
parameters are specified, then all traps are enabled.
Default
Format
Mode
ap-failure
ap-state
client-failure
client-state
peer-ws
rf-scan
rogue-ap
ws-status
no ap authentication
Wireless Config
trapflags
Disable
snmp-server enable traps wireless
Global Config
no snmp-server enable traps wireless
Global Config
All - Disable
trapflags [{ap-failure | ap-state | client-state | peer-ws | rf-
scan | rogue-ap | ws-status}]
Wireless Config
Enable/Disable SNMP traps associated with AP association/authentication
failures.
Enable/Disable SNMP traps associated with AP state changes.
Enable/Disable SNMP traps associated with client association/authentication
failures.
Enable/Disable SNMP traps associated with client state changes.
Enable/Disable SNMP traps associated with peer Unified Switch events.
Enable/Disable SNMP traps associated with RF scan related events.
Enable/Disable SNMP traps associated with rogue access points.
Enable/Disable SNMP traps associated with wireless status events.
command in Wireless Config Mode.
Unified Switch Commands
4 Wireless Commands
143