Config Traffic Control Auto_Recover_Time; Show Traffic Control - D-Link DGS-1210/ME Series Reference Manual

Restrictions
Example usage:
To configure traffic control and enable broadcast storm control system wide:
DGS-1210-28MP/ME:5# config traffic control all multicast enable unicast disable
broadcast enable threshold 64
Command: config traffic control all multicast enable unicast disable broadcast e
nable threshold 64
*Note: Setting count down for drop mode port was ignored.
Success.
DGS-1210-28MP/ME:5#

config traffic control auto_recover_time

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure auto recover time for traffic control:
DGS-1210-28MP/ME:5# config traffic control auto_recover_time 1000
Command: config traffic control auto_recover_time 1000
Success.
DGS-1210-28MP/ME:5#

show traffic control

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display traffic control setting for ports 1-3:
DGS-1210-28MP/ME:5# show traffic control 1-3
Command: show traffic control 1-3
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Only administrator or operator-level users can issue this command.
To configure the traffic auto recover time that allowed for a port to
recover from shutdown forever status.
config traffic control auto_recover_time [0 | <min 1-65535>]
The config
configures the auto recover time for traffic control.
[0 | <min 1-65535>] – Specifies the auto recover time for traffic
control The value is or from 1 to 65535.
Only administrator or operator-level users can issue this command.
To display current traffic control settings.
show traffic control {<portlist>}
The show traffic control command displays the current storm traffic
control configuration on the Switch.
<portlist> - A port or range of ports whose settings are to be
displayed.
None.
traffic control auto_recover_time
192
command