Config Mld_Snooping - D-Link DGS-1210/ME Series Reference Manual

Success.
DGS-1210-28MP/ME:5#

config mld_snooping

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure mld snooping:
DGS-1210-28MP/ME:5# config mld_snooping vlan_name default fast_done disable
host_timeout 130 leave_timer 3 router_timeout 60 state enable
Command: config mld_snooping vlan_name default fast_done disable host_timeout
130 leave_timer 3 router_timeout 60 state enable
Success.
DGS-1210-28MP/ME:5#
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To configure mld snooping.
config mld_snooping [vlan_name < string 32> | vlanid <vidlist> |
all] {fast_done [enable | disable] | host_timeout <sec 130-
153025> | leave_timer <sec 1-25> | report_suppression [enable |
disable] | router_timeout <sec 60-600> | state [enable | disable]}
The config mld_snooping command defines mld snooping on the
VLAN.
vlan_name <string 32> – Specifies that the mld snooping applies
only to this previously created VLAN.
vlanid <vidlist> – Specifies that the mld snooping applies only to this
VLAN id.
all – specifies that MLD snooping is to be configured for all VLANs
on the Switch.
fast_done [enable | disable] – Specifies the fast down to be enabled
or disabled.
host_timeout <sec 130-153025> – Specifies the maximum amount
of time a host can be a member of a multicast group without the
Switch receiving a host membership report. The default is 260
seconds.
leave_timer <sec 1-25> – Specifies the maximum amount of time a
host can be a member of a multicast group after sending a done
timer membership report. The default is 10 seconds.
report_suppression [enable | disable] – Specifies the report
suppression to be enabled or disabled.
router_timeout <sec 60-600> – Specifies the maximum amount of
time a route can be a member of a multicast group without the
Switch receiving a host membership report done timer. The default
is 300 seconds.
state [enable | disable]– Allows the user to enable or disable MLD
snooping for the specified VLAN.
Only administrator, operator or power user–level users can issue
this command.
348