The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
enable 802.1x
disable 802.1x
show 802.1x
auth_state
show 802.1x
auth_configuration
config 802.1x
auth_parameter ports
config 802.1x init
config 802.1x
auth_protocol
config 802.1x reauth
config radius add
config radius delete
config radius
show radius
config 802.1x fwd_pdu
system
show 802.1x fwd_pdu
system status
config 802.1x
auth_mode
create 802.1x guest
vlan
delete 802.1x guest
vlan
config 802.1x
guest_vlan ports
show 802.1x
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
{ports <portlist>}
{ports <portlist>}
[<portlist> | all] [default | { port_control [force_unauth | auto | force_auth] |
quiet_period <sec 0-65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-
65535> | server_timeout <sec 1-65535> | max_req <value 1-10> | reauth_period
<sec 1-65535> | enable_reauth [enable | disable] | direction [both | in]}]
port_based ports [<portlist> | all]
[radius_eap | local]
port_based ports [<portlist> | all]
<server_index 1-3> [<ipaddr> | <ipv6_addr>] [key <passwd 32>] {default |
auth_port <udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>
| retransmit <int 1-255> | timeout <int 1-255>}
<server_index 1-3>
<server_index 1-3> { key <passwd 32> | auth_port <udp_port_number 1-65535>
| acct_port <udp_port_number 1-65535> | ipaddress [<ipaddr> | <ipv6_addr>] |
retransmit <int 1-255> | timeout <int 1-255>}
[enable | disable]
[port_based | mac_based]
<vlan_name 32>
<vlan_name 32>
[<portlist> | all] state [enable | disable]
802.1X COMMANDS
367
47