xStack
config snmp linkchange_traps
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNMP linkchange traps on every port:
D G S –3 4 26 :5 # c on f ig s n m p l in kc h a ng e _t ra p s p o rt s a l l e na bl e
C o m ma n d: c o n fi g s nm p li n kc ha n g e_ t ra ps p or t s al l en a bl e
S u c ce s s.
D G S –3 4 26 :5 #
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to configure SNMP linkchange traps on the Switch.
config snmp linkchange_traps ports [all|<portlist>][enable|disable]
This command is used to configure SNMP linkchange traps on the Switch.
all − Configure all ports on the Switch.
<portlist> – Specifies a port or range of ports to be configured. The beginning and end of
the port list range are separated by a dash. Non-contiguous portlist entries are separated
by a comma. (ex: 1-3,7-9).
enable | disable – Used to enable or disable SMMP linkchange traps for the switch.
Only Administrator and Operator-level users can issue this command.
38