Network Monitoring Commands; Show Packet Ports - D-Link DGS-1210/ME Series Reference Manual

The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

show packet ports

show error ports
show utilization
clear counters
save log
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
cable diagnostic port
config syslogintimeout
config sysgroupinterval
show
log_software_module
Each command is listed in detail, as follows:
show packet ports
Purpose
Syntax
Description
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide

NETWORK MONITORING COMMANDS

Parameter
<portlist>
<portlist>
[ports {<portlist>} | cpu | mem]
{ports <portlist>}
{index <value 1-500> - <value 1-500> | module <string 32>}
<index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [informational | warning |
all] | facility [local0 | local1| local2 | local3 | local4 | local5 | local6 | local7] | state
[enable | disable] | udp_port [514 | <udp_port_number 6000-65535>]}
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | state [enable | disable] | udp_port
[ 514 | <udp_port_number 6000-65535>] | ipaddress [<ipaddr> | <ipv6addr>]}
[<index 1-4> | all]
{<index 1-4>}
[<portlist> | all]
<integer 3-30>
[<integer 120-1225> | 0]
To display statistics about the packets sent and received in frames
per second by the Switch.
show packet ports <portlist>
The show packet ports command displays statistics about packets
sent and received by ports specified in the port list. The results are
153
21