Automatic Transaxle Unit Dismounting And Remounting - Suzuki Liana RH418 Supplementary Service Manual

Automatic Transaxle Unit Dismounting and
Remounting
Dismounting
1) Take down transaxle with engine. For its procedure,
refer to "Engine Assembly Removal and Installation
in Section 1D".
2) Remove engine rear mounting No.1 bracket and
engine rear mounting No.2 bracket with stiffener.
3) Remove center bearing support bolts (3) and remove
center bearing support (2) with center shaft (1) from
differential side gear.
4) Remove lower stiffener.
1
5) Remove drive plate bolts.
To lock drive plate (1), engage a flat head rod or the
like (2) with drive plate gear.
2
6) Remove starting motor.
7) Remove bolts and nut fastening engine and
S3RH0B5106024
transaxle, then detach transaxle from engine.
NOTE
When detaching transaxle from engine, move
it in parallel with crankshaft and use care so
as not to apply excessive force to drive plate
and torque converter.
!
Be sure to keep transaxle with torque
converter horizontal or facing up throughout
the work. Should it be tilted with torque
converter down, converter may fall off and
cause personal injury.
3
2
I2RH01510089-01
1
I2RH01510090-01
Automatic Transmission/Transaxle:
WARNING
5A-79
I2RH01510091-02