Abs Hydraulic Unit / Control Module Assembly On-Vehicle Inspection; Abs Hydraulic Unit / Control Module Assembly Removal And Installation - Suzuki 2006 SX4 Service Manual

4E-30 ABS:
ABS Hydraulic Unit / Control Module Assembly
On-Vehicle Inspection
CAUTION
!
Never disassemble ABS hydraulic unit /
control module assembly, loosen blind plug
or remove motor. Performing any of these
prohibited services will affect original
performance of ABS hydraulic unit / control
module assembly.
Check hydraulic unit for fluid leakage.
If any, repair or replace.
ABS Hydraulic Unit / Control Module Assembly
Removal and Installation
CAUTION
!
Never disassemble ABS hydraulic unit /
control module assembly, loosen blind plug
or remove motor. Performing any of these
prohibited services will affect original
performance of ABS hydraulic unit / control
module assembly.
Removal
1) Disconnect negative cable from battery.
2) Disconnect ABS hydraulic unit / control module
assembly connector (1) by pull up the lock (2).
[A]
[A]: Disconnect
[B]: Connect
S6RW0C4506003
S6RW0C4506004
[B]
1
2
D
C
I5RW0A450001-01
C: Pull up to disconnect
D: Pull down to connect
3) Using special tool, loosen flare nuts (1) and
disconnect brake pipes (2) from ABS hydraulic unit /
control module assembly (3).
Special tool
(A): 09950-78220
NOTE
Put bleeder plug cap or the like onto pipe to
prevent fluid from spilling. Do not allow brake
fluid to get on painted surfaces.
2
1
(A)
4) Remove ABS hydraulic unit / control module with
bracket from vehicle by removing two bracket bolts.
5) Remove bolt and pull out ABS hydraulic unit / control
module assembly (1) from bracket (3) using flat end
rod or the like (2).
CAUTION
!
• Do not give an impact to hydraulic unit.
• Use care not to allow dust to enter
hydraulic unit.
• Do not place hydraulic unit on its side or
upside down. Handling it in inappropriate
way will affect its original performance.
3
I5RW0A450020-01
I5RW0A450021-01