Intermittent And Poor Connection Inspection - Suzuki Liana RH413 Service Manual

Short Circuit Check (wire harness to ground)
1) Disconnect negative (–) cable at battery.
2) Disconnect connectors at both ends of the circuit to
be checked.
NOTE
If the circuit to be checked is connected to
other parts (1), disconnect all connectors of
those parts.
Otherwise, diagnosis will be misled.
3) Measure resistance between terminal at one end of
circuit ("A-1" terminal in the figure) and body ground.
If continuity is indicated, it means that there is a short
to ground between terminals "A-1" and "C-1" of the
circuit.
4) Disconnect the connector included in circuit
(connector-B) and measure resistance between "A-
1" and body ground. If continuity is indicated, it
means that the circuit is shorted to the ground
between terminals "A-1" and "B-1".
1. To other parts

Intermittent and Poor Connection Inspection

Most intermittent are caused by faulty electrical
connections or wiring, although a sticking relay or
solenoid can occasionally be at fault. When checking it
for proper connection, perform careful check of suspect
circuits for:
• Poor mating of connector halves, or terminals not fully
seated in the connector body (backed out).
• Dirt or corrosion on the terminals. The terminals must
be clean and free of any foreign material which could
impede proper terminal contact. However, cleaning
the terminal with a sand paper or the like is prohibited.
• Damaged connector body, exposing the terminals to
moisture and dirt, as well as not maintaining proper
terminal orientation with the component or mating
connector.
• Improperly formed or damaged terminals.
Check each connector terminal in problem circuits
carefully to ensure good contact tension by using the
corresponding mating terminal.
If contact tension is not enough, reform it to increase
contact tension or replace.
I3RH0A000006-01
1. Check contact tension by inserting and removing just once.
2. Check each terminal for bend and proper alignment.
I2RH01010056-01
Precautions: 00-14
S3RH0A0006002
I2RH01010057-01
I3RH0A000007-01