Abs Warning Lamp Comes On Steady - Suzuki GRAND VITARA JB416 Service Manual

Troubleshooting
Step
1 1) Turn ignition switch to ON position.
Do other warning lamps come ON?
2 1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ignition switch to ON position and check DTC.
Is there DTC U1073?
3 Is Circuit fuse for combination meter in good condition?
4 Check CAN communication circuit between combination
meter and ABS (ESP®) control module referring to "DTC
U1073: Control Module Communication Bus Off: ".
Is CAN communication circuit in good condition?
5 1) Remove combination meter with ignition switch turned
OFF.
2) Check for proper connection to "PPL/RED" and "BLK"
wire of combination meter connector.
3) If OK, turn ON ignition switch and measure voltage at
"PPL/RED" wire of combination meter connector and
vehicle body ground.
Is it 10 – 14 V?
6 1) Measure resistance between "BLK" wire of combination
meter connector and vehicle body ground.
Is resistance less than 2

ABS Warning Lamp Comes ON Steady

Wiring Diagram
Refer to "ABS Warning Lamp Does Not Come ON at Ignition Switch ON: ".
Circuit Description
Operation (ON/OFF) of ABS warning lamp is controlled by ABS (ESP®) control module through lamp driver module in
combination meter.
If the Antilock brake system is in good condition, ABS (ESP®) control module turns ABS warning lamp ON at the
ignition switch ON, keeps it ON for 2 seconds and then turns it OFF. If an abnormality in the system is detected, ABS
warning lamp is turned ON continuously by ABS (ESP®) control module. Also, it is turned ON continuously by lamp
driver module when the connector of ABS (ESP®) control module is disconnected.
Action
Ω
?
Yes
Go to Step 2.
Go to "DTC U1073:
Control Module
Communication Bus
Off: ".
Go to Step 4.
Go to Step 5.
Go to Step 6.
Replace combination
meter.
ABS: 4E-14
No
Go to Step 3.
Substitute a known-
good combination meter
and recheck. If ABS
warning lamp remains
OFF, substitute a
known-good ABS
(ESP®) hydraulic unit /
control module
assembly and recheck.
Replace fuse and check
for short circuit to
ground.
Repair or replace.
Repair power supply
circuit for combination
meter.
"BLK" circuit open or
high resistance.
S5JB0E4504009