Suzuki Liana RH413 Service Manual page 26

0A-3 General Information:
Wire Color Symbols
Symbol
B BLK
Bl BLU
Br BRN
G GRN
Gr GRY
Lbl LT BLU
Lg LT GRN
There are two kinds of colored wire used in this vehicle. One is single-colored wire and the other is dual-colored
(striped) wire.
The single-colored wire uses only one color symbol (i.e. "GRN").
The dual-colored wire uses two color symbols (i.e. "GRN/YEL"). The first symbol represents the base color of the wire
("GRN" in the figure) and the second symbol represents the color of the stripe ("YEL" in the figure).
Fasteners Information
Metric Fasteners
Most of the fasteners used for this vehicle are metric. When replacing any fasteners, it is most important that
replacement fasteners be the correct diameter, thread pitch and strength.
Fastener Strength Identification
Most commonly used metric fastener strength property classes are 4T, 6.8, 7T, 8.8 and radial line with the class
identification embossed on the head of each bolt. Some metric nuts will be marked with punch, 6 or 8 mark strength
identification on the nut face. Figure shows the different strength markings.
When replacing metric fasteners, be careful to use bolts and nuts of the same strength or greater than the original
fasteners (the same number marking or higher). It is likewise important to select replacement fasteners of the correct
diameter and thread pitch. Correct replacement bolts and nuts are available through the parts division.
Metric bolts: Identification class numbers or marks correspond to bolt strength (increasing numbers represent
increasing strength).
Wire Color
Black O, Or
Blue
Brown
Green
Gray
Light blue
Light green
1. Nut strength identification
Symbol
ORN
R RED
W WHT
Y YEL
P PNK
V PPL
I2RH01010010-01
S3RH0A0101004
Wire Color
Orange
Red
White
Yellow
Pink
Violet
S3RH0A0101005
I2RH01010011-01