Table of Contents
Advertisement
5-34 BRAKES
1
1
M A X
M I
N
2
3
INSTALLATION
2
1
2
MASTER CYLINDER ASSEMBLY
REMOVAL
3
1) Apply brake fluid to new grommets and attach grommets (2)
to master cylinder (1).
NOTE:
Be sure to use new grommets.
2) Install reservoir (2) to master cylinder and insert retainer (1).
3) Install master cylinder.
4) Fill reservoir with specified brake fluid up to MAX mark on it.
5) After installation, purge air and check for brake fluid leakage.
1) Clean outside of master cylinder.
2) Drain brake fluid in reservoir.
3) Disconnect fluid level switch coupler (1) on reservoir.
4) Disconnect brake pipes (2) connected to master cylinder.
CAUTION:
Do not allow brake fluid to get on painted surface.
Painted surface will be damaged by brake fluid, flush it
with water immediately if any fluid is spilled.
5) Remove master cylinder fixing nuts (3).
6) Remove master cylinder and master cylinder gasket.
Advertisement
Table of Contents
