Configuration Examples; Example For Configuring A Single Rrpp Ring - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
When there is an RRPP running fault, run the following debugging command in the user view
to view the debugging information. The debugging information helps to locate and analyze the
fault.
Procedure
Step 1 Run the debugging rrpp [ domain domain-id [ ring ring-id ] ] { error | event | packet | all }
command in the user view to debug RRPP.
----End

3.6 Configuration Examples

This section provides several configuration examples of RRPP.

3.6.1 Example for Configuring a Single RRPP Ring

Networking Requirements
As shown in
A, Switch B, and Switch C are on ring 1 of RRPP domain 1. The data of VLANs 100 to 300
needs to be protected.
Figure 3-5 Networking diagram of a single RRPP ring
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Issue 01 (2011-10-26)
Figure 3-5, Switch A, Switch B, and Switch C support the RRPP function. Switch
SwitchB
Ethernet0/0/2
Ethernet0/0/1
Ring 1
Ethernet0/0/2
Ethernet0/0/2
Ethernet0/0/1
Map instance 1 to VLANs 100 to 300.
Locate Switch A, Switch B, and Switch C on ring 1 of RRPP domain 1.
Configure Switch A as the master node on ring 1, and configure Switch B and Switch C as
transit nodes on ring 1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Ethernet0/0/1
SwitchC
Primary Port
Secondary port
3 RRPP Configuration
74