Checking The Configuration - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
oam-mgr
The OAM management view is displayed.
Step 3 Run the following command as required.
l Run:
l Run:
l Run:
----End

4.14.3 Checking the Configuration

Prerequisite
The Configuration of association between EFM OAM and Ethernet CFM are complete.
Procedure
Step 1 In the OAM management view, run the display this command to check association between
EFM OAM and Ethernet CFM.
[Quidway-oam-mgr]display this
#
Issue 01 (2011-10-26)
oam-bind cfm md md-name ma ma-name efm interface interface-type interface-number
The EFM OAM and Ethernet CFM modules are configured to send fault messages to each
other.
oam-bind ingress efm interface interface-type interface-number egress cfm md md-
name ma ma-name
The EFM OAM module is configured to send fault messages to the Ethernet CFM module.
oam-bind ingress cfm md md-name ma ma-name egress efm interface interface-type
interface-number
The Ethernet CFM module is configured to send fault messages the EFM OAM module.
NOTE
After Ethernet OAM is associated with other functional modules,
l If EFM OAM is disabled on an interface, the association between EFM OAM and other functional
modules is deleted.
l If an MA or MD is deleted, the association between Ethernet CFM and other functional modules is
deleted.
NOTE
If you run oam-bind cfm md md-name ma ma-name efm interface interface-type interface-number
command, two records of the oam-bind ingress efm interface interface-type interface-number egress
cfm md md-name ma ma-name and oam-bind ingress cfm md md-name ma ma-name egress efm
interface interface-type interface-number commands are displayed. In the records, the directions where
fault notification messages are transmitted are reverse.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
205