Creating And Enabling A Smart Link Group; Configuring The Master And Slave Interfaces In A Smart Link Group - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
No.
3
4
5

2.2.2 Creating and Enabling a Smart Link Group

Context
Do as follows on the S3700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
smart-link group group-id
A Smart Link group is created and the Smart Link group view is displayed.
The S3700 supports a maximum of 16 Smart Link groups.
Step 3 (Optional)Run:
protected-vlan reference-instance { instance-id1 [ to instance-id2 ] }&<1-10>
An instance is bound to the Smart Link group as the protected instance. The functions of the
Smart link group take effect only on the VLANs bound to the protected instance. For details
about STP instance configuration, see Configuring and Activating an MST Region.
----End
2.2.3 Configuring the Master and Slave Interfaces in a Smart Link
Group
Context
The slave interface of a Smart Link group is blocked when the group is started.
An interface cannot be added to a Smart Link group in the following situations:
l
l
l
Issue 01 (2011-10-26)
Data
IDs of VLANs bound to the instance
Control VLAN ID contained in the Flush packet
(Optional) Password contained in the Flush packet
NOTE
By default, a Smart Link group protects all VLANs and the protected-vlan reference-instance command
is applicable only to multicast services.
The interface is a Rapid Ring Protection Protocol (RRPP) interface.
Spanning Tree Protocol (STP) is enabled on the interface.
The interface has been added to an Eth-Trunk.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Smart Link and Monitor Link Configuration
18