Huawei Quidway S3700 Series Configuration Manual page 138

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
l Run the display rrpp verbose domain command on PE-AGG. You can obtain the following
l Run the display rrpp ring-group command on UPE B to view the configuration of the ring
Issue 01 (2011-10-26)
Is Enabled : Enable
Common port : Ethernet0/0/1
Edge port : Ethernet0/0/4
The preceding information shows that VLAN 10 is the control VLAN in domain 2, and
VLANs mapping instance 2 are the protected VLANs.
UPE B is a transit node in domain 2 and is in LinkUp state.
UPE B is a transit node on ring 2 in domain 2 and is in LinkUp state. Eth 0/0/1 is the public
port, and Eth 0/0/3 is the edge port.
UPE B is a transit node on ring 3 in domain 2 and is in LinkUp state. Eth 0/0/1 is the public
port, and Eth 0/0/4 is the edge port.
results:
# View detailed information about PE-AGG in domain 1.
[PE-AGG] display rrpp verbose domain 1
Domain Index : 1
Control VLAN : major 5
Protected VLAN: Reference Instance 1
Hello Timer : 1 sec(default is 1 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Master
Ring State : Complete
Is Enabled : Enable
Primary port : Ethernet0/0/1
Secondary port: Ethernet0/0/2
The preceding information shows that VLAN 5 is the control VLAN in domain 1, and VLANs
mapping instance 1 are the protected VLANs.
PE-AGG is the master node in domain 1 and is in Complete state.
Eth 0/0/1 is the primary port, and Eth 0/0/2 is the secondary port.
# View detailed information about PE-AGG in domain 2.
[PE-AGG] display rrpp verbose domain 2
Domain Index : 2
Control VLAN : major 10
Protected VLAN: Reference Instance 2
Hello Timer : 1 sec(default is 1 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Master
Ring State : Complete
Is Enabled : Enable
Primary port : Ethernet0/0/2
Secondary port: Ethernet0/0/1
The preceding information shows that VLAN 10 is the control VLAN in domain 2, and
VLANs mapping instance 2 are the protected VLANs.
PE-AGG is the master node in domain 2 and is in Complete state.
Eth 0/0/2 is the primary port, and Eth 0/0/1 is the secondary port.
group.
# View the configuration of ring group 1.
[UPEB] display rrpp ring-group 1
Ring Group 1:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Port status: UP
Port status: UP
sub 6
Fail Timer : 6 sec(default is 6 sec)
Port status: UP
Port status: BLOCKED
sub 11
Fail Timer : 6 sec(default is 6 sec)
Port status: UP
Port status: BLOCKED
3 RRPP Configuration
Is Active : Yes
Is Active : Yes
Is Active : Yes
126