Example For Configuring Tangent Rrpp Rings With Multiple Instances - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
l
3.6.6 Example for Configuring Tangent RRPP Rings with Multiple
Instances
Networking Requirements
As shown in
ring 1 in domain 1 and ring 1 in domain 2. UPE D, UPE E, UPE F, and UPE G form ring 1 in
domain 3. Packets of the data VLANs connected to CE are forwarded to the backbone network
through the two tangent rings.
The tangent point of the two rings is UPE D.
VLANs 100 to 300 are configured on CE. Domain 1 and domain 2 share the traffic of packets
from VLANs 100 to 300. Packets from VLANs 100 to 200 are transmitted through domain 1,
and packets from VLANs 201 to 300 are transmitted through domain 2.
Issue 01 (2011-10-26)
stp disable
#
interface Ethernet0/0/2
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
return
Configuration file of PE-AGG
#
sysname PE-AGG
#
vlan batch 5 to 6 10 to 11 100 to 300
#
rrpp enable
rrpp linkup-delay-timer 1
#
stp region-configuration
instance 1 vlan 5 to 6 100 to 200
instance 2 vlan 10 to 11 201 to 300
active region-configuration
#
rrpp domain 1
control-vlan 5
protected-vlan reference-instance 1
ring 1 node-mode master primary-port Ethernet 0/0/1 secondary-port Ethernet
0/0/2 level 0
ring 1 enable
rrpp domain 2
control-vlan 10
protected-vlan reference-instance 2
ring 1 node-mode master primary-port Ethernet 0/0/2 secondary-port Ethernet
0/0/1 level 0
ring 1 enable
#
interface Ethernet0/0/1
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
interface Ethernet0/0/2
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
return
Figure 3-10, UPE A, UPE B, UPE C, and UPE D form two multi-instance rings:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RRPP Configuration
131