Example For Configuring Tangent Rrpp Rings - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
l

3.6.3 Example for Configuring Tangent RRPP Rings

Networking Requirements
As shown in
RRPP function. Switch A, Switch B, and Switch C are on ring 2 of domain 2. Switch C, Switch
D, and Switch E are on ring 1 of domain 1. Switch C is the tangent point of the two rings.
Issue 01 (2011-10-26)
stp disable
#
return
Configuration file of Switch D
#
sysname SwitchD
vlan batch 2 to 11
#
rrpp enable
#
stp region-
configuration
instance 1 vlan 2 to
11
active region-
configuration
#
rrpp domain 1
control-vlan 10
protected-vlan reference-instance 1
ring 1 node-mode transit primary-port Ethernet 0/0/2 secondary-port Ethernet
0/0/1 level 0
ring 1 enable
ring 2 node-mode assistant-edge common-port Ethernet 0/0/2 edge-port
Ethernet 0/0/3
ring 2 enable
#
interface Ethernet0/0/1
port link-type trunk
port trunk allow-pass vlan 2 to 11
stp disable
#
interface Ethernet0/0/2
port link-type trunk
port trunk allow-pass vlan 2 to 11
stp disable
#
interface Ethernet0/0/3
port link-type trunk
port trunk allow-pass vlan 2 to 11
stp disable
#
return
Figure 3-7, Switch A, Switch B, Switch C, Switch D, and Switch E support the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RRPP Configuration
88