Huawei Quidway S3700 Series Configuration Manual page 268
Hide thumbs
Also See for Quidway S3700 Series:
- Configuration manual (289 pages) ,
- Quick start manual (70 pages) ,
- Manual (69 pages)
Table of Contents
Advertisement
Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
VSI Name
MAC
CCM Receive
Trigger-If-Down
CFM Status
Alarm Status
Run the display interface command on PE-AGG to check the status of Eth 0/0/1, and you can
find that Eth 0/0/1 is in TRIGGER DOWN (1AG) state.
[PE-AGG] display interface ethernet0/0/1
Ethernet0/0/1 current state : TRIGGER DOWN
(1AG)
Line protocol current state : DOWN
Description:HUAWEI, Quidway Series, Ethernet0/0/1 Interface
Switch Port,PVID :
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-8211-1111
Port Mode: COMBO AUTO
Current Work Mode: COPPER
Speed : 1000,
Duplex: FULL,
Mdi
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input peak rate 0 bits/sec,Record time: -
Output peak rate 0 bits/sec,Record time: -
Input:
Unicast
Broadcast
CRC
Jabbers
Runts
Alignments
Ignoreds
Discard
Output:
Unicast
Broadcast
Collisions
Late Collisions:
Buffers Purged :
Discard
Run the display rrpp verbose domain 1 command on PE-AGG to check the status of the RRPP
ring and interface, and following information is displayed:
[PE-AGG] display rrpp verbose domain 1
Domain Index
Control VLAN
Protected VLAN: Reference Instance 1
ello Timer
RRPP Ring
Ring Level
Node Mode
Ring State
Is Enabled
Primary port
Secondary port: Ethernet0/0/2
The status of the RRPP ring becomes Failed and the secondary interface changes from
BLOCKED to UP.
Issue 01 (2011-10-26)
: --
: --
: enabled
: disabled
: up
: RemoteAlarms
1,The Maximum Frame Length is 1600
Loopback: NONE
Negotiation: DISABLE
: AUTO
0 packets, 0 bytes
:
:
:
:
:
:
:
:
0 packets, 0 bytes
:
:
:
:
Input bandwidth utilization threshold : 100.00%
Output bandwidth utilization threshold: 100.00%
Input bandwidth utilization
Output bandwidth utilization : 0.00%
: 1
: major 5
: 1 sec(default is 1 sec)
: 1
: 0
: Master
: Failed
: Enable
: Ethernet0/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
0,Multicast
0,Jumbo
0,Giants
0,Throttles
0,DropEvents
0,Symbols
0,Frames
0,Total Error
0,Multicast
0,Jumbo
0,Deferreds
0,ExcessiveCollisions:
0
0,Total Error
: 0.00%
sub 6
Fail Timer : 3 sec(default is 3 sec)
Is Active : Yes
Port status: DOWN
Port status: UP
4 Ethernet OAM Configuration
:
0
:
0
:
0
:
0
:
0
:
0
:
0
:
0
:
0
:
0
:
0
0
:
0
256
Advertisement
Table of Contents
