Optional) Configuring Load Balancing In A Smart Link Group - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
If you run flush send control-vlan vlan-id [ password simple password ] command in the Smart
Link group view, the Smart Link group is enabled to send Flush packets that contain the specified
control VLAN ID and password. The VLAN ID specified by vlan-id must already exist on the
S3700. If the specified VLAN ID does not exist on the S3700, Flush packets cannot be sent.
Do as follows on the S3700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
smart-link group group-id
The Smart Link group view is displayed.
Step 3 Run:
flush send control-vlan vlan-id [ password simple password ]
The S3700 is enabled to send Flush packets, and the control VLAN ID and password contained
in Flush packets are set.
A control VLAN cannot be a VLAN mapping a load-balancing instance.
The control VLAN ID and password contained in Flush packets on both devices must be the
same. That is, the control VLAN ID and password in Flush packets sent by the device must be
the same as the control VLAN ID and password in Flush packets received by the device.
After the flush send control-vlan command is run, the interface cannot be added to the control VLAN. You need
to configure the interface to allow the packets of the control VLAN to pass through.
----End

2.2.5 (Optional) Configuring Load Balancing in a Smart Link Group

Context
Do as follows on the S3700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
stp region-configuration
The Multiple Spanning Tree (MST) region view is displayed.
Step 3 Run:
instance instance-id vlan { vlan-id1 [ to vlan-id2 ] }&<1-10>
Issue 01 (2011-10-26)
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Smart Link and Monitor Link Configuration
20