Resetting The Dldp Status; Establishing The Configuration Task; Resetting The Dldp Status Globally - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
DLDP port state : advertisement
DLDP link state : up
The neighbor number of the port is 1.
Interface Ethernet0/0/2
DLDP port state : advertisement
DLDP link state : up
The neighbor number of the port is 1.

1.3 Resetting the DLDP Status

This section describes how to reset the DLDP status.

1.3.1 Establishing the Configuration Task

Applicable Environment
When a unidirectional link is detected, the corresponding interface enters the Disable state. The
system prompts you to disable the interface or sets the interface state to DLDP Down
automatically according to the configuration. To enable the interface to detect unidirectional
links again, you can reset the DLDP state of the interface. The DLDP status of the interface after
recovery depends on the physical status of the interface. If the physical status is Down, the DLDP
status of the interface changes to Inactive. If the physical status is Up, the DLDP status changes
to Active.
Pre-configuration Tasks
None.
Data Preparation
To reset the DLDP status, you need the following data.
No.
1
2

1.3.2 Resetting the DLDP Status Globally

Context
The dldp reset command takes effect only when DLDP is enabled globally and on interfaces.
Issue 01 (2011-10-26)
Neighbor mac address : 0000-0000-0100
Neighbor port index : 21
Neighbor state : two way
Neighbor aged time : 13
Neighbor mac address : 0000-0000-1100
Neighbor port index : 22
Neighbor state : two way
Neighbor aged time : 12
Data
Type and number of each interface
Name of the interface group
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 DLDP Configuration
9