Checking The Configuration - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
The system view is displayed.
Step 2 Run:
rrpp domain domain-id
The domain view is displayed.
Step 3 Run:
timer hello-timer hello-value fail-timer fail-value
The values of RRPP domain timers are set.
The value of the Fail timer is equal to or more than three times the value of the Hello timer.
The value of the Edge-hello timer defaults to half the value of the Hello timer of the master node
on the major ring.
Set consistent Hello timers and Fail timers on all the nodes in the same RRPP ring domain;
otherwise, the edge ports of the edge nodes might be unstable.
----End

3.3.11 Checking the Configuration

Procedure
l
l
l
l
----End
Example
Run the display stp region-configuration command, and you can view the mapping between
MSTIs and VLANs. The following is an example:
<Quidway> display stp region-configuration
Oper configuration
Run the display rrpp brief command, and you can view information such as the node mode,
RRPP status, control VLAN, protected VLAN, and values of timers. The following is an
example:
<Quidway> display rrpp brief
Abbreviations for Switch Node Mode :
Issue 01 (2011-10-26)
Run the display stp region-configuration command to check the mapping between MSTIs
and VLANs.
Run the display rrpp brief [ domain domain-id ] command to check brief information
about an RRPP domain.
Run the display rrpp verbose domain domain-id [ ring ring-id ] command to check
detailed information about an RRPP domain.
Run the display rrpp statistics domain domain-id [ ring ring-id ] command to check the
statistics of packets in an RRPP domain.
Format selector :0
Region name :00e0cd568d00
Revision level :0
Instance Vlans Mapped
0 3 to 99, 301 to 4094
1 1, 100 to 200
2 2, 201 to 300
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RRPP Configuration
60