Huawei Quidway S3700 Series Configuration Manual page 101

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Figure 3-7 Networking diagram of tangent RRPP rings
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data.
l
l
Procedure
Step 1 Create an instance and add the control VLANs added to the list of protected VLANs.
# Configure Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] stp region-configuration
[SwitchA-mst-region] instance 2 vlan 20 to 21
[SwitchA-mst-region] active region-configuration
[SwitchA-mst-region] quit
# Configure Switch B.
<Quidway> system-view
[Quidway] sysname SwitchB
Issue 01 (2011-10-26)
Domain 2
SwtichB Ethernet0/0/2
Ethernet0/0/1
Ethernet0/0/2
SwtichA
Ethernet0/0/1
Create an instance and add the control VLANs added to the list of protected VLANs.
Configure ring 2 of domain 2 on Switch A, Switch B, and Switch C.
Configure ring 1 of domain 1 on Switch C, Switch D, and Switch E.
Configure Switch A as the master node on ring 2, and configure Switch B and Switch C as
transit nodes on ring 2.
Configure Switch E as the master node on ring 1, and configure Switch C and Switch D as
transit nodes on ring 1.
Numbers of the RRPP interfaces
Control VLAN IDs of ring 1 and ring 2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Ethernet0/0/3
Ethernet0/0/2
Ring 2 SwtichC
Ethernet0/0/1
Ethernet0/0/3
3 RRPP Configuration
Domain 1
Ethernet0/0/1
SwtichE
Ethernet0/0/2
Ring 1
Ethernet0/0/1
Ethernet0/0/2
SwtichD
89