Optional) Enabling Dldp Compatible Mode - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability

1.2.4 (Optional) Enabling DLDP Compatible Mode

Context
If the S3700 needs to work with the following Huawei switches to provide the DLDP function,
this task is required. The software versions of the following switches must support the DLDP
function:
l
l
l
l
l
l
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bpdu mac-address mac-address [ mac-address-mask ]
The S3700 is configured to use the BPDU MAC address 010F-E200-0001 to send DLDP packets.
The MAC addresses used for sending DLDP packets on the S3700 and on the old Huawei
switches are different. Therefore, the S3700 must be configured to use BPDU MAC address
10F-E200-0001 to send DLDP packets.
Step 3 Run:
interface interface-type interface-number
The interface view is displayed.
Or run:
port-group port-group-name
The port group view is displayed.
Step 4 Run:
dldp compatible-mode enable
The DLDP compatible mode is enabled.
If two devices are connected by using two links, the DLDP compatible mode must be enabled
or disabled on both the two interfaces.
If devices at both ends are S3700s, the interfaces at both ends must use the same DLDP
compatible mode. That is, you must enable or disable the DLDP compatible mode
simultaneously on the interfaces.
Issue 01 (2011-10-26)
S8500
S7800
S6500
S5600
S5100–EI
S3900
S3500
S3100
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 DLDP Configuration
5