Huawei Quidway S3700 Series Configuration Manual page 318

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Figure 6-2 Networking diagram for configuring single-hop BFD on a VLANIF interface
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Default values of minimum intervals for sending BFD control packets, minimum intervals for
receiving BFD control packets, and local detection multipliers
Procedure
Step 1 On Switch A and Switch B, create VLAN 13, configure Eth 0/0/1 interfaces as hybrid interfaces,
and add Eth 0/0/1 interfaces to VLAN 13.
# Configure Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] vlan 13
[SwitchA-vlan13] quit
[SwitchA] interface ethernet 0/0/1
[SwitchA-Ethernet0/0/1] port hybrid pvid vlan 13
[SwitchA-Ethernet0/0/1] port hybrid untagged vlan 13
[SwitchA-Ethernet0/0/1] quit
# Configure SwitchB.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] vlan 13
[SwitchB-vlan13] quit
[SwitchB] interface ethernet 0/0/1
[SwitchB-Ethernet0/0/1] port hybrid pvid vlan 13
[SwitchB-Ethernet0/0/1] port hybrid untagged vlan 13
[SwitchB-Ethernet0/0/1] quit
Issue 01 (2011-10-26)
VLANIF 13
VLANIF 13
10.1.1.6/24
10.1.1.5/24
Ethernet0/0/1 Ethernet0/0/1
Create VLAN 13 on Switch A and Switch B.
Configure Eth 0/0/1 interfaces on Switch A and Switch B as hybrid interfaces.
Create VLANIF 13 on Switch A and Switch B and set their IP address.
Create a BFD session on Switch A to detect the link between Switch A and Switch B.
Create a BFD session on Switch B to detect the link between Switch B and Switch A.
Numbers of VLANIF interfaces bound to BFD sessions
IP addresses of VLANIF interfaces
Local and remote discriminators of BFD sessions
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
6 BFD Configuration
306