Creating A Mep - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Follow-up Procedure
An MA is associated with a VLAN only.
l
l

4.8.7 Creating a MEP

A MEP is an edge node of an MA. It is configured on an interface manually.
Context
When creating a MEP in an MA, pay attention to the following points:
l
l
The requirements for the MEPs created in an MA on the same S3700 are as follows:
l
l
Do as follows on the edge devices of an MA.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm md md-name
The MD view is displayed.
Step 3 Run:
ma ma-name
The MA view is displayed.
Step 4 Run:
mep mep-id mep-id interface interface-type interface-number [ vlan vlan-id | pe-
vid pe-vid ce-vid ce-vid ] { inward | outward }
A MEP is created on an interface.
----End
Follow-up Procedure
Perform the preceding steps as required:
Issue 01 (2011-10-26)
If you need to create multiple MAs in an MD, repeat Step 3 and Step 4.
If you need to create multiple MAs in multiple MDs, repeat Step 2 to Step 4.
When creating an inward MEP, ensure that the MA has been associated with a VLAN and
the interface on which the MEP is located has been added to the VLAN. An inward MEP
sends 802.1ag packets through all the interfaces in the VLAN associated with the MA
except the interface on which the MEP is located. That is, an inward MEP broadcasts
802.1ag packets in the VLAN associated with the MA.
Protocol packets sent from the outward MEP are forwarded by this interface.
The inward MEP and outward MEP are mutually exclusive.
Only one outward MEP can be created. Multiple inward MEPs can be created, but only
one inward MEP can be created on an interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
180