Configuring Association Between Ethernet Cfm And Ethernet Cfm; Checking The Configuration - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
No.
1
2
4.15.2 Configuring Association Between Ethernet CFM and
Ethernet CFM
Context
Do as follows on the devices where association between Ethernet CFM and Ethernet CFM needs
to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
oam-mgr
The OAM management view is displayed.
Step 3 (Optional) Run:
oam-bind ingress cfm md md-name1 ma ma-name1 egress cfm md md-name2 ma ma-name2
Unidirectional fault transmission is enabled between Ethernet CFM modules at the two ends of
the link.
Step 4 (Optional) Run:
oam-bind cfm md md-name1 ma ma-name1 cfm md md-name2 ma ma-name2
Bidirectional fault transmission is enabled between Ethernet CFM modules at the two ends of
the link.
Steps 3 to 4 are optional and can be selected as required.
----End

4.15.3 Checking the Configuration

Prerequisite
The configurations of association between Ethernet CFM and Ethernet CFM are complete.
Issue 01 (2011-10-26)
Data
Interface to be associated and number of the interface
Names of the MD and MA
NOTE
After bidirectional transmission of fault messages is configured, the system displays two configuration
records of unidirectional fault message transmission, whose directions are mutually reverse.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
207