Example For Configuring Vrrp6 In Load Balancing Mode - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability

7.11.5 Example for Configuring VRRP6 in Load Balancing Mode

Networking Requirements
As shown in
l
l
l
Figure 7-7 Networking of VRRP in load balancing mode
HostA
2000::3/64
HostB
2000::4/64
Device
Switch A
Switch B
Switch C
Issue 01 (2011-10-26)
interface Ethernet0/0/1
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
return
Figure 7-7,
Switch A is the master device in VRRP group 1 and the backup device in VRRP group 2.
Switch B is the master device in VRRP group 2 and the backup device in VRRP group 1.
Host A on the LAN uses the virtual IPv6 address of VRRP group 1 as the gateway address,
and Host B uses the virtual IPv6 address of VRRP group 2 as the gateway address. The
two VRRP groups load balance traffic and back up each other.
Backup group 1
Virtual IP Address
2000::100
Ethernet0/0/1
Ethernet0/0/1
Ethernet
Backup group 2
Virtual IP Address
2000::60
Interface
Eth 0/0/1
Eth 0/0/2
Eth 0/0/1
Eth 0/0/2
Eth 0/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchA
group 1:Master
group 2:Backup
Ethernet0/0/2
Ethernet0/0/1
SwitchC
Ethernet0/0/2
SwitchB
group 1:Backup
group 2:Master
VLANIF interface
VLANIF100
VLANIF200
VLANIF100
VLANIF400
VLANIF200
7 VRRP and VRRP6 Configuration
Ethernet0/0/3
HostC
Ethernet0/0/2
2003::1/64
IP address
2000::1/64
2002::1/64
2000::2/64
2001::1/64
2002::2/64
367