Example For Configuring Association Between Ethernet Cfm With Ethernet Cfm - Huawei Quidway S3700 Series Configuration Manual
Hide thumbs
Also See for Quidway S3700 Series:
- Configuration manual (289 pages) ,
- Quick start manual (70 pages) ,
- Manual (69 pages)
Table of Contents
Advertisement
Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
l
4.18.8 Example for Configuring Association Between Ethernet CFM
with Ethernet CFM
Networking Requirements
As shown in
between Switch B and Switch C. When a fault occurs on the link between Switch A and Switch
B, Ethernet CFM is triggered to send fault messages to Switch C. Then, alarms are generated
on Switch C.
Issue 01 (2011-10-26)
efm enable
#
cfm enable
#
interface Ethernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
efm enable
bpdu enable
#
interface Ethernet0/0/2
port link-type trunk
port trunk allow-pass vlan 10
#
cfm md md1
ma ma1
map vlan 10
mep mep-id 2 interface ethernet0/0/2 outward
mep ccm-send enable
remote-mep mep-id 1
remote-mep ccm-receive mep-id 1 enable
#
oam-mgr
oam-bind ingress efm interface Ethernet0/0/1 egress cfm md md1 ma ma1
oam-bind ingress cfm md md1 ma ma1 egress efm interface Ethernet0/0/1
#
return
Configuration file of Switch D
#
sysname SwitchD
#
vlan batch 10
#
efm enable
#
interface Ethernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
efm mode passive
efm enable
bpdu enable
#
interface Ethernet0/0/2
port link-type trunk
port trunk allow-pass vlan 10
#
return
Figure
4-19, Ethernet CFM is configured between Switch A and Switch B, and
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
243
Advertisement
Table of Contents
