Huawei Quidway S3700 Series Configuration Manual page 257

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Step 3 Configure Ethernet CFM between Switch B and Switch C.
# Configure Switch B.
[SwitchB] cfm enable
[SwitchB] cfm md md1
[SwitchB-md-md1] ma ma2
[SwitchB-md-md1-ma-ma2] map vlan 20
[SwitchB-md-md1-ma-ma2] mep mep-id 1 interface ethernet 0/0/2 outward
[SwitchB-md-md1-ma-ma2] remote-mep mep-id 2
[SwitchB-md-md1-ma-ma2] mep ccm-send enable
[SwitchB-md-md1-ma-ma2] remote-mep ccm-receive enable
[SwitchB-md-md1-ma-ma2]
[SwitchB-md-md1] quit
# Configure Switch C.
<Quidway> system-view
[Quidway] sysname SwitchC
[SwitchC] cfm enable
[SwitchC] cfm md md1
[SwitchC-md-md1] ma ma2
[SwitchC-md-md1-ma-ma2] map vlan 20
[SwitchC-md-md1-ma-ma2] mep mep-id 2 interface ethernet 0/0/2 outward
[SwitchB-md-md1-ma-ma2] remote-mep mep-id 1
[SwitchC-md-md1-ma-ma2] mep ccm-send enable
[SwitchC-md-md1-ma-ma2] remote-mep ccm-receive enable
[SwitchC-md-md1-ma-ma2] quit
[SwitchC-md-md1] quit
Run the display cfm remote-mep command on Switch B to check the CFM status, and you can
find that the CFM status is Up.
[SwitchB] display
The total number of RMEPs is : 2
--------------------------------------------------
MD Name
Level
MA Name
RMEP ID
Vlan ID
VSI Name
MAC
CCM Receive
Trigger-If-Down
CFM Status
Alarm Status
MD Name
Level
MA Name
RMEP ID
Vlan ID
VSI Name
MAC
CCM Receive
Trigger-If-Down
CFM Status
Alarm Status
Step 4 Configure association between Ethernet CFM and Ethernet CFM.
# Associate Ethernet CFM between Switch A and Switch B with Ethernet CFM between Switch
B and Switch C in both directions. That is, enable Ethernet CFM modules to send trap messages
to each other.
Issue 01 (2011-10-26)
quit
cfm remote-mep
: md1
: 0
: ma1
: 1
: 10
: --
: --
: enabled
: disabled
: up
: RemoteAlarms
: md1
: 0
: ma2
: 2
: 20
: --
: --
: enabled
: disabled
: up
: RemoteAlarms
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
245