Optional) Enabling The Receiving Of Flush Packets; Huawei Proprietary And Confidential - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
The system view is displayed.
Step 2 Run:
smart-link group group-id
The Smart Link group view is displayed.
Step 3 Run:
restore enable
Revertive switching is enabled for the Smart Link group.
By default, the revertive switching of the Smart Link group is disabled.
Step 4 (Optional) Run:
timer wtr wtr-time
The wait to recover (WTR) time of the Smart Link group is set.
By default, the WTR time of a Smart Link group is 60 seconds.
----End

2.2.7 (Optional) Enabling the Receiving of Flush Packets

Context
An interface receives Flush packets only when it is configured with the control VLAN ID and
added to this VLAN.
Do as follows on SwitchA, SwitchB, and SwitchC shown in
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The view of the downlink interface of the SwitchA, SwitchB, or SwitchC is displayed.
Step 3 Run:
smart-link flush receive control-vlan vlan-id [ password simple password ]
The interface is enabled to receive Flush packets, and the control VLAN ID and password
contained in Flush packets are set.
The password is optional. If no password is specified, no password is used for authentication.
When the control VLAN ID is changed, the password must also be changed.
The control VLAN ID and password contained in Flush packets on both devices must be the
same. That is, the control VLAN ID and password in Flush packets sent by the device must be
the same as the control VLAN ID and password in Flush packets received by the device.
----End
Issue 01 (2011-10-26)

Huawei Proprietary and Confidential

Copyright © Huawei Technologies Co., Ltd.
2 Smart Link and Monitor Link Configuration
Figure 2-1.
22