Huawei Quidway S3700 Series Configuration Manual page 153
Hide thumbs
Also See for Quidway S3700 Series:
- Configuration manual (289 pages) ,
- Quick start manual (70 pages) ,
- Manual (69 pages)
Table of Contents
Advertisement
Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
[UPEF] rrpp domain 3
[UPEF-rrpp-domain-region3] ring 1 node-mode master primary-port ethernet 0/0/1
secondary-port ethernet 0/0/2 level 0
[UPEF-rrpp-domain-region3] ring 1 enable
[UPEF-rrpp-domain-region3] quit
l Configure UPE G.
# Configure UPE G as a transit node of ring 1 in domain 3 and specify primary and secondary
ports on UPE G.
[UPEG] rrpp domain 3
[UPEG-rrpp-domain-region3] ring 1 node-mode transit primary-portethernet 0/0/1
secondary-port ethernet 0/0/2 level 0
[UPEG-rrpp-domain-region3] ring 1 enable
[UPEG-rrpp-domain-region3] quit
Step 5 Enable the RRPP protocol.
After configuring an RRPP ring, you need to enable RRPP on each node on the ring to activate
the RRPP ring. The configuration procedure is as follows:
l Configure UPE A.
# Enable the RRPP protocol.
[UPEA] rrpp enable
l # Configure UPE B.
# Enable the RRPP protocol.
[UPEB] rrpp enable
l Configure UPE C.
# Enable the RRPP protocol.
[UPEC] rrpp enable
l Configure UPE D.
# Enable the RRPP protocol.
[UPED] rrpp enable
l Configure UPE E.
# Enable the RRPP protocol.
[UPEE] rrpp enable
l Configure UPE F.
# Enable the RRPP protocol.
[UPEF] rrpp enable
l Configure UPE G.
# Enable the RRPP protocol.
[UPEG] rrpp enable
Step 6 Verify the configuration.
After the preceding configurations are complete and the network topology becomes stable,
perform the following operations to verify the configuration. Here, UPE D is taken for example.
Issue 01 (2011-10-26)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RRPP Configuration
141
Advertisement
Table of Contents
