Huawei Quidway S3700 Series Configuration Manual page 285

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Figure 5-4 Networking diagram of configuring the one-way frame delay measurement in a
VLAN
Ethernet0/0/1
Ethernet0/0/1
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configuring synchronize clock, For the configuration procedure, see NTP Configuration
Step 2 Configure VLANs.
# Configure Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] vlan 2
[SwitchA-vlan2] quit
[SwitchA] interface ethernet 0/0/1
[SwitchA-Ethernet0/0/1] port link-type trunk
[SwitchA-Ethernet0/0/1] port trunk allow-pass vlan 2
[SwitchA-Ethernet0/0/1] quit
# Configure Switch B.
Issue 01 (2011-10-26)
SwitchC
Ethernet0/0/2
SwitchA
Configure VLANs on Switch A, Switch B, Switch C, and Switch D.
Configure MDs and MAs on Switch A and Switch B.
Configure outward-facing MEPs on Switch A and Switch B.
Set the alarm thresholds of the one-way frame delay measurement on Switch A.
Enable the one-way frame delay measurement for the VLANs on Switch A
VLAN ID
Alarm threshold of the one-way frame delay measurement
Names of the MD and MA
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 ITU-T Recommendation Y.1731 Configuration
SwitchD
Ethernet0/0/2
SwitchB
Ethernet0/0/1
Ethernet0/0/1
273