Example For Configuring Association Between An Ethernet Cfm Module And An Interface - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
4.18.6 Example for Configuring Association Between an Ethernet
CFM Module and an Interface
Networking Requirements
As shown in
configured between Switch A and SwitchB, and Ethernet CFM is associated with Eth 0/0/1 of
Switch A. When the CFM OAM module on Switch A detects the connectivity fault on the link
between Switch A and Switch B, it shuts down Eth 0/0/1. In this case, the peer device of
SwitchA detects the fault.
Figure 4-17 Networking diagram for associating an Ethernet CFM module with an interface
SwitchC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Procedure
Step 1 Create VLANs and add interfaces to the VLANs.
# Configure Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] vlan 10
[SwitchA-vlan10] quit
[SwitchA] interface ethernet 0/0/2
[SwitchA-Ethernet0/0/2] port link-type trunk
[SwitchA-Ethernet0/0/2] port trunk allow-pass vlan 10
[SwitchA-Ethernet0/0/2] quit
# Configure SwitchB.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] vlan 10
[SwitchB-vlan10] quit
[SwitchB] interface ethernet 0/0/1
[SwitchB-Ethernet0/0/1] port link-type trunk
[SwitchB-Ethernet0/0/1] port trunk allow-pass vlan 10
[SwitchB-Ethernet0/0/1] quit
Step 2 Enable Ethernet CFM.
# Enable Ethernet CFM globally on Switch A.
Issue 01 (2011-10-26)
Figure 4-17, CFM is used on a direct link and a multi-hop link. Ethernet CFM is
Ethernet0/0/1
SwitchA
Interface associated with CFM OAM
Configure Ethernet CFM on Switch A and Switch B.
Associate an Ethernet CFM module with Eth 0/0/1 on SwitchA.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
CFM OAM
Ethernet0/0/1
Ethernet0/0/2
SwitchB
4 Ethernet OAM Configuration
236