Huawei Quidway S3700 Series Configuration Manual page 395

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
tester analyzes connectivity and performance of the Ethernet network and Switch B based on
the received Ethernet frames.
Figure 9-3 Networking diagram of a local MAC swap loopback test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Create VLAN 100, configure GE 0/0/1 as trunk interface and GE 0/0/2 as a hybrid interface,
and add the interfaces to VLAN 100.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] vlan batch 100
[SwitchB] interface gigabitethernet0/0/1
[SwitchB-GigabitEthernet0/0/1] port link-type trunk
[SwitchB-GigabitEthernet0/0/1] port trunk allow-pass vlan 100
[SwitchB-GigabitEthernet0/0/1] quit
[SwitchB] interface ethernet0/0/2
[SwitchB-Ethernet0/0/2] port hybrid pvid vlan 100
[SwitchB-Ethernet0/0/2] port hybrid untagged vlan 100
Step 2 Configure local MAC swap loopback on GE 0/0/2 and specify GE 0/0/1 as the outbound interface
of loopback Ethernet frames. Enable the MAC swap loopback function.
Issue 01 (2011-10-26)
Tester
Ethernet
Create a VLAN, configure GE 0/0/1 as a trunk interface and GE 0/0/2 as a hybrid interface,
and add the interfaces to the VLAN.
Configure local MAC swap loopback on Switch B.
Enable the MAC swap loopback function on Switch B.
VLAN ID: 100
Source and destination MAC addresses of test Ethernet frames: 0018-2000-0085 and
0018-2000-0070
Timeout period of the loopback test: 80s
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE0/0/1 Eth0/0/2
SwitchB
9 MAC Swap Loopback Configuration
Users
383