Huawei Quidway S3700 Series Configuration Manual page 106

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
l Run the display rrpp verbose domain command on Switch C to view the domain
----End
Issue 01 (2011-10-26)
RRPP Protocol Status:
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 2
Domain Index : 1
Control VLAN : major 10
Protected VLAN : Reference Instance 1
Hello Timer : 2 sec(default is 1 sec)
Ring Ring Node
ID Level Mode
---------------------------------------------------------------------------
1 0 T
Domain Index : 2
Control VLAN : major 20
Protected VLAN : Reference Instance 2
Hello Timer : 3 sec(default is 1 sec)
Ring Ring Node
ID Level Mode
---------------------------------------------------------------------------
2 0 T
You can find that RRPP is enabled on Switch C. The main control VLAN of domain 1 is
VLAN 10 and the sub control VLAN is VLAN 11. Switch C is the master node of ring 1,
with Eth 0/0/1 as the primary interface and Eth 0/0/2 as the secondary interface.
The main control VLAN of domain 2 is VLAN 20, and the sub control VLAN is VLAN 21.
Switch C is a transit node on ring 2, with Eth 0/0/3 as the primary interface and Eth 0/0/4 as
the secondary interface.
information.
# View detailed information about domain 1.
[SwitchC] display rrpp verbose domain 1
Domain Index : 1
Control VLAN : major 10
Protected VLAN : Reference Instance 1
Hello Timer : 2 sec(default is 1 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Transit
Ring State : Linkup
Is Enabled : Enable
Primary port : Ethernet0/0/1
Secondary port: Ethernet0/0/2
# View detailed information about domain 2.
[SwitchC] display rrpp verbose domain 2
Domain Index : 2
Control VLAN : major 20
Protected VLAN : Reference Instance 2
Hello Timer : 3 sec(default is 1 sec)
RRPP Ring : 2
Ring Level : 0
Node Mode : Transit
Ring State : Linkup
Is Enabled : Enable
Primary port : Ethernet0/0/3
Secondary port: Ethernet0/0/4
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Enable
sub 11
Fail Timer : 7 sec(default is 6 sec)
Primary/Common
Port
Ethernet0/0/1
sub 21
Fail Timer : 10 sec(default is 6 sec)
Primary/Common
Port
Ethernet0/0/3
sub 11
Fail Timer : 7 sec(default is 6 sec)
Is Active : Yes
Port status: UP
Port status: UP
sub 21
Fail Timer : 10 sec(default is 6 sec)
Is Active : Yes
Port status: UP
Port status: UP
3 RRPP Configuration
Secondary/Edge
Port
Ethernet0/0/2
Secondary/Edge
Port
Ethernet0/0/4
Is
Enabled
Yes
Is
Enabled
Yes
94