Optional) Configuring The Rmep Activation Time - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Data Preparation
To adjust parameters of Ethernet CFM, you need the following data.
No.
1
2
3

4.9.2 (Optional) Configuring the RMEP Activation Time

The RMEP activation time is reserved for you to configure an RMEP. After the configuration
of the RMEP activation time, the local device can receive CCMs after the configured RMEP
activation time expires.
Context
Do as follows on each edge device in an MA:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm md md-name
The MD view is displayed.
Step 3 Run:
ma ma-name
The MA view is displayed.
Step 4 Run:
active time time
The RMEP activation time is configured.
----End
Issue 01 (2011-10-26)
Data
(Optional) RMEP activation time
(Optional) Anti-jitter time during alarm restoration
(Optional) Anti-jitter time during alarm generation
NOTE
IEEE 802.1ag has two versions, that is, IEEE 802.1ag Draft 7 and IEEE Standard 802.1ag-2007. The cfm
default md command can be used only on the device complying with IEEE Standard 802.1ag-2007. Before
using the cfm default md command, you must use the cfm version command to set the IEEE 802.1ag
version to IEEE Standard 802.1ag-2007.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
188