Huawei Quidway S3700 Series Configuration Manual page 97

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
l Run the display rrpp verbose domain command on Switch A. The following information
l Run the display rrpp brief command on Switch D. The following information is displayed:
Issue 01 (2011-10-26)
RRPP Protocol Status:
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 1
Domain Index : 1
Control VLAN : major 10
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec)
Ring Ring Node
ID Level Mode
-------------------------------------------------------------------------
1 0 T
2 1 E
You can find that RRPP is enabled on Switch A. The main control VLAN is VLAN 10, and
the sub control VLAN is VLAN 11. Switch A is the transit node of the major ring, with
Eth 0/0/2 as the primary interface and Eth 0/0/1 as the secondary interface.
Switch A is also an edge of the subring, with Eth 0/0/2 as the common interface and Eth 0/0/3
as the edge interface.
is displayed:
[SwitchA] display rrpp verbose domain 1
Domain Index : 1
Control VLAN : major 10
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Transit
Ring State : Linkup
Is Enabled : Enable
Primary port : Ethernet0/0/2
Secondary port: Ethernet0/0/1
RRPP Ring : 2
Ring Level : 1
Node Mode : Edge
Ring State : Linkup
Is Enabled : Disable
Common port : Ethernet0/0/2
Edge port : Ethernet0/0/3
[SwitchD] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status:
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 1
Domain Index : 1
Control VLAN : major 10
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec)
Ring Ring Node
ID Level Mode
-------------------------------------------------------------------------
1 0 T
2 1 A
You can find that RRPP is enabled on Switch D. The main control VLAN is VLAN 10, and
the sub control VLAN is VLAN 11. Switch D is the transit node of the major ring, with
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Enable
sub 11
Fail Timer : 6 sec(default is 6 sec)
Primary/Common
Port
Ethernet0/0/2
Ethernet0/0/2
sub 11
Fail Timer : 6 sec(default is 6 sec)
Is Active : Yes
Port status: UP
Port status: UP
Is Active : No
Port status: UP
Port status: UP
Enable
sub 11
Fail Timer : 6 sec(default is 6 sec)
Primary/Common
Port
Ethernet0/0/2
Ethernet0/0/2
3 RRPP Configuration
Secondary/Edge
Port
Ethernet0/0/1
Ethernet0/0/3
Secondary/Edge
Port
Ethernet0/0/1
Ethernet0/0/3
Is
Enabled
Yes
Yes
Is
Enabled
Yes
Yes
85