Creating An Rmep; Optional) Setting The Mip Creation Rule - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
l
l
l

4.8.8 Creating an RMEP

For other devices in the same MA, their MEPs are RMEPs for the local device. By configuring
an RMEP, you can perform connectivity fault detection between the local MEP and the RMEP
in one MA.
Context
If you need to detect the connectivity between a device and an RMEP, you need to create the
RMEP first.
Do as follows on the edge devices of an MA:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm md md-name
The MD view is displayed.
Step 3 Run:
ma ma-name
The MA view is displayed.
Step 4 Run:
remote-mep mep-id mep-id [ mac mac-address ]
An RMEP in the current MA is created.
----End
Follow-up Procedure
l
l
l

4.8.9 (Optional) Setting the MIP Creation Rule

Context
Do as follows on each S3700 where Ethernet CFM needs to be configured.
Issue 01 (2011-10-26)
To create multiple MEPs in an MA, repeat Step 4.
To create MEPs in multiple MAs, repeat Step 3 and Step 4.
To create MEPs in multiple MDs, repeat Step 2 to Step 4.
If you need to create multiple RMEPs in an MA, repeat Step 4.
If you need to create multiple RMEPs in multiple MAs, repeat Step 3 and Step 4.
If you need to create multiple RMEPs in multiple MDs, repeat Step 2 to Step 4.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
181