Huawei Quidway S3700 Series Configuration Manual page 117

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Hello Timer
Ring
ID
----------------------------------------------------------------------------
1
Domain Index
Control VLAN
Protected VLAN : Reference Instance 2
Hello Timer
Ring
ID
----------------------------------------------------------------------------
1
You can see that the RRPP protocol is enabled on UPE A.
In domain 1, VLAN 5 is the control VLAN; VLANs mapping instance 1 are the protected
VLANs; UPE A is a transit node on ring 1. The primary port is Eth 0/0/1, and the secondary
port is Eth 0/0/2.
In domain 2, VLAN 10 is the control VLAN; VLANs mapping instance 2 are the protected
VLANs; UPE A is a transit node on ring 1. The primary port is Eth 0/0/1, and the secondary
port is Eth 0/0/2.
l Run the display rrpp brief command on PE-AGG. The following information is displayed:
[PE-AGG] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 2
Domain Index
Control VLAN
Protected VLAN : Reference Instance 1
Hello Timer
Ring
ID
---------------------------------------------------------------------------
1
Domain Index
Control VLAN
Protected VLAN: Reference Instance 2
Hello Timer
Ring
ID
---------------------------------------------------------------------------
1
The preceding information shows that the RRPP protocol is enabled on PE-AGG.
In domain 1, VLAN 5 is the control VLAN; VLANs mapping instance 1 are the protected
VLANs; PE-AGG is the master node on ring 1. The primary port is Eth 0/0/1, and the secondary
port is Eth 0/0/2.
In domain 2, VLAN 10 is the control VLAN; VLANs mapping instance 2 are the protected
VLANs; PE-AGG is the master node on ring 1. The primary port is Eth 0/0/2, and the secondary
port is Eth0/0/1.
Issue 01 (2011-10-26)
: 1 sec(default is 1 sec)
Ring Node Primary/Common
Level Mode Port
0 T Ethernet0/0/1
: 2
: major 10
: 1 sec(default is 1 sec)
Ring Node Primary/Common
Level Mode Port
0 T Ethernet0/0/1
: 1
: major 5 sub 6
: 1 sec(default is 1 sec)
Ring Node Primary/Common
Level Mode Port
0 M Ethernet0/0/1
: 2
: major 10
: 1 sec(default is 1 sec)
Ring Node Primary/Common
Level Mode Port
0 M Ethernet0/0/2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Fail Timer : 6 sec(default is 6 sec)
Secondary/Edge
Port
Ethernet0/0/2
sub 11
Fail Timer : 6 sec(default is 6 sec)
Secondary/Edge
Port
Ethernet0/0/2
Fail Timer : 6 sec(default is 6 sec)
sub 11
Fail Timer : 6 sec(default is 6 sec)
3 RRPP Configuration
Secondary/Edge
Port
Ethernet0/0/2
Secondary/Edge
Port
Ethernet0/0/1
Is
Enabled
Yes
Is
Enabled
Yes
Is
Enabled
Yes
Is
Enabled
Yes
105