Huawei Quidway S3700 Series Configuration Manual page 226

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
Figure 4-13 Networking diagram for testing the packet loss ratio on the link
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure basic functions of EFM OAM.
# Enable EFM OAM globally on Switch B.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] efm enable
# Enable EFM OAM globally on Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] efm enable
# Configure EFM OAM on Eth 0/0/1 of Switch A to work in passive mode.
[SwitchA] interface ethernet 0/0/1
[SwitchA-Ethernet0/0/1] bpdu enable
[SwitchA-Ethernet0/0/1] efm mode passive
# Enable EFM OAM on Ethernet 0/0/1 of Switch A.
Issue 01 (2011-10-26)
SwitchA
Ethernet0/0/1
User
network
Ethernet0/0/1
Enable EFM OAM on Switch A and Switch B. Configure EFM OAM on Eth 0/0/1 of
Switch A to work in passive mode.
Enable EFM OAM remote loopback on Switch B.
Send test packets from Switch B to Switch A.
Check the returned test packets on Switch B.
Timeout interval for EFM OAM remote loopback
Size, number, and sending rate of test packets
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
Internet
4 Ethernet OAM Configuration
214