Example For Configuring The Two-Way Frame Delay Measurement In A Vlan - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
5.5.2 Example for Configuring the Two-way Frame Delay
Measurement in a VLAN
When you need to estimate service qualities, you can configure the two-way frame delay
measurement on point-to-point MEPs to obtain the performance of the network.
Networking Requirements
As shown in
and Switch B. The interval for sending DM frames is set to 10 seconds and the number of DM
frames sent each time is also set to 10.
Figure 5-5 Networking diagram of configuring the two-way frame delay measurement in a
VLAN
Ethernet0/0/1
Ethernet0/0/1
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Issue 01 (2011-10-26)
#
vlan batch 2
#
interface Ethernet0/0/1
port link-type trunk
port trunk allow-pass vlan 2
#
interface Ethernet0/0/2
port link-type trunk
port trunk allow-pass vlan 2
#
return
Figure 5-5, the two-way frame delay measurement is deployed both on Switch A
SwitchC
Ethernet0/0/2
SwitchA
Configure VLANs on Switch A, Switch B, Switch C, and Switch D.
Configure MDs and MAs on Switch A and Switch B.
Configure outward-facing MEPs on Switch A and Switch B.
Set the alarm thresholds of the two-way frame delay measurement on Switch A and Switch
B.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 ITU-T Recommendation Y.1731 Configuration
SwitchD
Ethernet0/0/2
SwitchB
Ethernet0/0/1
Ethernet0/0/1
277