Huawei Quidway S3700 Series Configuration Manual page 105
Hide thumbs
Also See for Quidway S3700 Series:
- Configuration manual (289 pages) ,
- Quick start manual (70 pages) ,
- Manual (69 pages)
Table of Contents
Advertisement
Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
[SwitchC] rrpp domain 2
[SwitchC-rrpp-domain-region2] ring 2 node-mode transit primary-port ethernet 0/0/3
secondary-port ethernet 0/0/4 level 0
[SwitchC-rrpp-domain-region2] ring 2 enable
[SwitchC-rrpp-domain-region2] quit
Configure nodes on ring 1. The configuration procedure is as follows:
# Configure Switch E as the master node of ring 1 (major ring) and specify the primary and
secondary interfaces.
[SwitchE] rrpp domain 1
[SwitchE-rrpp-domain-region1] ring 1 node-mode master primary-port ethernet 0/0/1
secondary-port ethernet 0/0/2 level 0
[SwitchE-rrpp-domain-region1] ring 1 enable
[SwitchE-rrpp-domain-region1] quit
# Configure Switch C as a transit node of ring 1 and specify the primary and secondary interfaces.
[SwitchC] rrpp domain 1
[SwitchC-rrpp-domain-region1] ring 1 node-mode transit primary-port ethernet 0/0/1
secondary-port ethernet 0/0/2 level 0
[SwitchC-rrpp-domain-region1] ring 1 enable
[SwitchC-rrpp-domain-region1] quit
# Configure Switch D as a transit node of ring 1 and specify the primary and secondary interfaces.
[SwitchD] rrpp domain 1
[SwitchD-rrpp-domain-region1] ring 1 node-mode transit primary-port ethernet 0/0/1
secondary-port ethernet 0/0/2 level 0
[SwitchD-rrpp-domain-region1] ring 1 enable
[SwitchD-rrpp-domain-region1] quit
Step 6 Enable RRPP.
After configuring an RRPP ring, enable RRPP on each node on the ring. Then the RRPP ring
can be activated.
# Enable RRPP on Switch A.
[SwitchA] rrpp enable
# Enable RRPP on Switch B.
[SwitchB] rrpp enable
# Enable RRPP on Switch C.
[SwitchC] rrpp enable
# Enable RRPP on Switch E.
[SwitchE] rrpp enable
# Enable RRPP on Switch D.
[SwitchD] rrpp enable
Step 7 Verify the configuration.
After the configurations are complete and network become stable, run the following commands
to verify the configuration. Take the tangent point Switch C for example.
l Run the display rrpp brief command on Switch C. The following information is displayed:
Issue 01 (2011-10-26)
[SwitchC] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RRPP Configuration
93
Advertisement
Table of Contents
