Huawei Quidway S3700 Series Configuration Manual page 239

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
3.
4.
5.
6.
7.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Switch IEEE 802.1ag Draft 7 to IEEE Standard 802.1ag-2007.
# Switch IEEE 802.1ag Draft 7 to IEEE Standard 802.1ag-2007 on Switch A.
<SwitchA> system-view
[SwitchA] cfm version standard
Warning: CFM will be disabled before the version of CFM is changed, and all info
rmation about the MD will be deleted . Continue?[Y/N]:y
Info: Succeeded in changing the version of CFM.
# Switch IEEE 802.1ag Draft 7 to IEEE Standard 802.1ag-2007 on Switch B, Switch C, Switch
D, Switch E, and Switch F.
The configurations on Switch B, Switch C, Switch D, Switch E, and Switch F are similar to the
configuration on Switch A, and are not mentioned here.
Step 2 Create VLANs and add interfaces to the VLANs. The configuration procedure is not mentioned
here.
Step 3 Create MD 1.
# Create MD 1 on Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
Issue 01 (2011-10-26)
Create MD 1 at level 6 on all the devices except for Switch B and Switch C.
Create MD 2 at level 4 on Switch B and Switch C.
Create the default MD at level 6 on Switch B and Switch C, associate the default MD with
VLAN 2 and VLAN 3, and set the MIP creation rule to default.
Create and configure MA 1 in MD 1 on all the devices except for Switch E. Associate MA
1 with VLAN 2.
Create and configure MA 2 in MD 1 on all the devices except for Switch F. Associate MA
2 with VLAN 3.
Create and configure MEPs and RMEPs on MA 1 in MD 1 of Switch A and Switch F.
Create and configure MEPs and RMEPs on MA 2 in MD 1 of Switch A and Switch E.
Enable the function of sending and receiving CCMs.
IDs of VLANs to which the sub-interfaces are to be added
Level of MD 1: 6
Level of MD 2: 4
Level of the default MD: 6
NOTE
By default, IEEE 802.1ag Draft 7 is enabled on a device.
NOTE
All the devices on the entire network must be enabled with either IEEE 802.1ag Draft 7 or IEEE Standard
802.1ag-2007. IEEE 802.1ag Draft 7 and IEEE Standard 802.1ag-2007 cannot be enabled at the same time
on a network.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
227